Verizon Delphi Connect Uživatelská příručka stáhnout pdf (Strana 32)

100

101

Note: Typically, all of the warning lamps on the dashboard will illuminate brieﬂy in this position.

Note: For pushbutton-start vehicles, the procedure is typically to push the Start button without your foot on

the brake (check your vehicle owner’s manual to determine how many presses are required to turn the ignition

on).

2. Press and hold the Function Button on the side of the Vehicle Diagnostics Module until the

Status LED blinks red one time. This will occur after approximately 5 seconds. Then release

the Function Button. The LED will blink red several times while vehicle setup occurs.

3. Wait up to 30 seconds for the LED to display a mix of solid and blinking green.

4. Wait until the LED stops ﬂashing green and goes out.

5. When the LED begins to ﬂash blue every 10 seconds, setup is complete.

Stop! Do not proceed if the Status LED never turned green and returned to solid blue. Your

vehicle may not be compatible with the Vehicle Diagnostics Module (check ﬁtment guide

connectedcar.delphi.com/ﬁtment) or you did not place the ignition in the On position.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 460 461

Komentáře k této Příručce

Žádné komentáře

Verizon Delphi Connect Uživatelská příručka Strana 32

Komentáře k této Příručce